11/10/2022 0 Comments Rheingold bmw ista pQuestion: Where (what path) do you place the SDP contents to support flashing from ISTA? Also, where do you place the BLP contents as well?Īnswer: Put the two folders data and data_swi in C:\Rheingold\PSdZ > The setting was to go into Network Settings, select the USB Loopback which has been renamed ” Ethernet 2 ” and rename it to “USB” then go into its settings just like you would ENET lead and set the IPV4 IP to 169.254.0.8 with a mask of 255.255.0.0 The Windows Networking and Networking Toolkit for Networking and Networking. However I did it nicely and ISTA-P runs nicely too, and with the excellent Loader V4.3. Loader V3.2 and ISTA-P was a bit more tricky. Put all correct files in sharedstorage and install all.Īfter the Windows 10 update (which failed the first two attempts because it turned out the BIOS needed an update first) most applications were fine.īy simply revisiting the COM port settings for my K DCAN USB to set back to COM9, minimum buffer sizes and minimum latency Rheingold ran perfectly. Install Vredist 20, net framework 4.6.1 or 4.6.2 Start using engineering software (INPA, WinKFP, etc.) The IP address must be set to correct 169.254.92.38, click “CHECK” buttonĬonfiguration is done. ICOM Device status will be changed to Reserved.Ģ) Open Eas圜onnect, do following settings. Select vehicle type, BMW, MINI, BMW Motorcycle or Rolls RoyceĬlick “Extras” tab> “Settings” to change language and other settingsĬlick “Settings” to change language and othersĮngineering
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |